3D Squirtle!

Hello again! This was a printable Squirtle. I pulled the model from Models-Resource.com and remodeled it to be printed. The overall print went well. I think next time i will slow down the speed i think i ran it too fast at 80mm/min.  Enjoy the video and thanks for watching!

Printer Printrbot Metal Plus
Slicer Simplify3D
Nozzle .040 mm
Print Speed 70-80mm
Layer Height 0.28 mm
Shells 2
Raft Yes – Offset: 8mm
Infill 10%
Support Yes
Extrude Temp 1-10 Layer= 210c, 19-x Layer=190c
Bed Temp 50c
Material PLA
Print Time about an hour 1/2.

Squirtle

Squirtle
8

Ease of print

8/10

    Pros

    • The print came out great, these settings worked great for a Squirtle withing 2 hours.

    Cons

    • Requires a lot of supports,
    • The support in the mouth takes a lot of time to get out.

    Be the first to comment

    Leave a Reply

    Your email address will not be published.


    *